OPERATING SECTION 4
Page 31
DRESSTA OM560C99/1E
DRIVING THE MACHINE
Fig. 4.22. Starting and Stopping the Machine
22 - Transmission and Instrument Panel Lights
Check Switch
28 - Parking Brake Switch
42 - Brake Pedal
43 - Transmission Neutral Lock Lver
44 - Transmission Gear Range Lever
45 - Transmission Direction Lever
49 - Bucket Control Lever
50 - Boom Control Lever
51 - Accelerator Pedal
WARNING! Before operating the machine observe strictly the following
precautions:
a) never haul passengers in the cab if the loader is equipped with a cab for the
operator only,
b) never allow anyone to stand on steps or on the platform when driving and
operating the machine,
c) Sit in the operator’s seat before operating any controls or switches,
d) Keep your hands and footwear free of grease, water and mud to insure
positive control movement,
e) Before driving the machine, adjust the seat and seat belt to fit snugly and
low around the hips,
f) Sound the horn to warn the nearby personnel,
g) Never try to get on or off the machine when it is moving,
H) Check all instruments, gauges and warning lights for correct operation
To start moving perform the following steps in accordance with Fig. 4.22:
1. Depress and hold down brake pedal 42.
2. Release parking brake 28.
3. Raise the boom with lever 50 until the bucket is off the ground and in carry position.
4. Rollback the bucket with lever 49.
5. Unlock transmission direction lever 45 and place it in the required direction forward or reverse.
ATTENTION: If the machine is equipped with a back-up alarm, the alarm will sound when the
direction lever is placed in REVERSE.
6. Place the transmission gear range lever 44 in the 1st gear (foremost position).
7. Release brake pedal 42 and gradually depress accelerator pedal 51 until the machine starts
moving.
To Next Page
Loading...