OPERATING SECTION 4
Page 43
DRESSTA OM560C99/1E
LOADER TECHNIQUES
Sequence of bank loading is shown in Fig. 4.40.
Fig. 4.40. Bank Loading
Heavy roots of large trees may require cutting from several sides of the tree (Fig. 4.41). Upon
completion of cutting push the tree as described above for small trees removal. Use a cable to
topple and remove trees from soft ground. Topple the tree, back the loader and lower the bucket to
the ground and push the tree from the site.
Fig. 4.41. Removing Large Trees
The wheel loader can be used for removing objects employing breakout force. However, avoid
removing of spring materials because it may cause splitting of the material.
Employ breakout force available applying the load in the middle of the bucket width.
The wheel loader may be used for pushing and pressing against brick walls, etc. following the
procedure for a tree removal. For those operations the bucket must be positioned horizontally.
The wheel loader may be used for towing trailers or pulling the loads, if necessary, however
spinning of the wheels must be avoided.
To Next Page
Loading...