Restoring the DEFAULT unit of measurement:
It is possible to restore the units of measurement of
all indications displayed on the instrument panel.
Use (1) and (2) to select "DEFAULT" with
flashing frame (Fig 130) and press (4).
“WAIT..” will be displayed for 2 seconds. Successively,
the "DF - OK” (Fig 131) message will be displayed for
another 2 seconds to indicate that the units of
measurement have been restored.
Successively, the display will show the flashing
“SPEED” indication again (Fig 126).
Fig 130
Fig 131
140
To Next Page
Loading...
