Duke E SERIES Service Manual

Service Manual for Electric Convection Oven
10
Z CONTROL PANEL ASSEMBLY
WARNING: DISCONNECT OVEN FROM POWER
SOURCE BEFORE PERFORMING
ANY SERVICE.
Component Access Procedure
Remove screw at top center of Z Control Panel assembly
and slide control panel out to allow access to Control
Panel components.
Power
Switch
Nut
Temperature
Probe
Screw
Knob
Oven
Ready
Light
Fuse Holder &
Fuse (10 amp delay)
5
/
9
WARNING
Lexan
Control
Panel
Knob
Digital
Control
Panel
Z
Controller
POWER Switch
1. Perform Component Access Procedure.
2. Loosen setscrew and remove knob from POWER
Switch.
3. Tag and disconnect wires from POWER Switch.
4. Remove nut securing POWER Switch.
5. Reverse procedure to install POWER Switch.
Z Controller
1. Perform Component Access Procedure.
2. Tag and disconnect wires from Controller.
3. Remove two knobs from front of Control Panel.
4. Remove four nuts securing Controller to Control
Panel.
5. Remove Controller from rear of Control Panel.
6. Reverse procedure to install a new Controller.
OVEN READY Light
1. Perform Component Access Procedure.
2. Tag and disconnect wires to OVEN READY Light.
3. Remove OVEN READY Light from front of panel.
4. Reverse procedure to install a new OVEN READY
Light.
Fuse and Fuse Holder Light
1. Remove Fuse Holder cap to replace Fuse.
2. Perform Component Access Procedure.
3. Tag and disconnect wires to Fuse Holder.
4. Remove nut securing Fuse Holder.
5. Remove Fuse Holder from front of Control Panel.
6. Reverse procedure to install a new Fuse Holder.
LIGHT Switch
NOTE: LIGHT Switch is only on the 6/13 Oven.
1. Perform Component Access procedure.
2. Tag and disconnect wires from LIGHT Switch.
3. Remove LIGHT Switch from front of Control Panel.
4. Reverse procedure to install a new LIGHT Switch.

Duke E SERIES Specifications

General

Brand	Duke
Model	E SERIES
Category	Oven
Language	English