Duke E SERIES - Rear Mounted Motor

17
Service Manual for Electric Convection Oven
Inside back panel
Fan
Set
Screws
5. Inside the Oven, loosen setscrews on Blower (Fan)
and remove Fan from Motor Shaft.
6. Remove right side access panel.
7. At right side of oven, label and disconnect motor
wires at Motor Junction Box.
Nut
Mounting
Plate
Motor
Junction
Box
8. Remove four nuts securing Motor to Mounting Plate
and remove Motor.
9. Reverse procedure to install Motor.
Rear Mounted Motor
WARNING: DISCONNECT OVEN FROM POWER
SOURCE BEFORE PERFORMING
ANY SERVICE.
1. Open Oven Doors.
2. Remove shelves.
3. Remove two side racks.
4. Remove four screws attaching back plate and
remove back plate to access Motor.
5. Loosen setscrews on Blower (Fan) and remove
Fan from Motor Shaft.
Rack
Back
Panel
Light
Bulb
Panel
ShelfFan
6. At rear of oven, label and disconnect Motor wires
at Motor Junction Box.
7. Remove four nuts securing Motor to Mounting Plate
and remove Motor.
8. Reverse procedure to install Motor.