Duke E SERIES - 59-E3 P Oven Controls; Component Access Procedure; POWER Switch; Controller

Service Manual for Electric Convection Oven
14
59-E3P OVEN CONTROLS
WARNING: DISCONNECT OVEN FROM POWER
SOURCE BEFORE PERFORMING
ANY SERVICE.
Component Access Procedure
Remove screw at top center of 59-E3P Control Panel
assembly and slide Control Panel assembly out to allow
access to Control Panel components.
Power
Switch
Temperature
Probe
Knob
Oven
Ready
Light
Fuse Holder &
Fuse (10 amp delay)
5
/
9
WARNING
Mylar
Panel
Digital
Control
Panel
Screw
1
2
3
4
5
Transformer
Contactor
Terminal
Block
E3P
Controller
POWER Switch
1. Perform Component Access Procedure.
2. Loosen set screws and remove knob from POWER
Switch.
3. Tag and disconnect wires from POWER Switch.
4. Remove nut securing POWER Switch and remove
POWER Switch.
5. Reverse procedure to install a new POWER Switch.
Controller
1. Perform Component Access Procedure.
2. Tag and disconnect wires from Controller.
3. Remove nuts securing Controller to Control Panel.
4. Remove Controller from rear of Control Panel.
5. Reverse procedure to install a new Controller.
OVEN READY Light
1. Perform Component Access procedure.
2. Tag and disconnect wires to OVEN READY Light.
3. Remove OVEN READY Light from front of panel.
4. Reverse procedure to install a new OVEN READY
Light.
NOTE: Transformer, Contactor, and Terminal Block are
mounted on a panel behind the Oven Control.
Fuse and Fuse Holder Light
1. Remove Fuse Holder Cap to replace Fuse.
2. Perform Component Access Procedure.
3. Tag and disconnect wires to Fuse Holder.
4. Remove nut securing Fuse Holder.
5. Remove Fuse Holder from front of Control Panel.
6. Reverse procedure to install a new Fuse Holder.
Transformer
Refer to TRANSFORMER in this section.
Contactor
1. Perform Component Access Procedure.
2. Tag and disconnect wires to Contactor.
3. Remove four nuts and remove Contactor.
4. Reverse procedure to install a new Contactor.
Terminal Block
1. Perform Component Access Procedure.
2. Tag and disconnect wires to Terminal Block.
3. Remove four nuts and remove Terminal Block.
4. Reverse procedure to install a new Terminal Block.