29
Service Manual for Electric Convection Oven
19. To change between automatic and manual use
the Right or Left arrow keys.
20. Press the “P” key. HOLD FAN SPEED will be
displayed then either HIGH or LOW.
21. To change the hold fan speed settings, use the
Left or Right arrow keys.
22. Press the “P” key. SETBACK TIME will be displayed
then the current setback time (XX:XX).
23. To change the Setback time, using the recipe keys
enter the new setback time.
24. Press the “P” key. SETBACK TEMP will be
displayed with the current setback temperature
(XXXF or XXXC).
25. Using the recipe keys, type in the new setback
temperature.
26. Press the “P” key. PREHEAT TIME will be
displayed, then current preheat time (XX:XX).
27. To change the preheat time, enter the new preheat
time using the recipe keys.
28. Press the “P” key. SYSTEM will be displayed.
29. To exit the system, press the Up arrow key and
EXIT will be displayed.
30. Press the “P” key to exit the System Programming.
Factory Programming
1. Press and hold the “P” key and hold it for three
seconds. PRODUCT CNT will be displayed.
2. Press the Down Arrow key until PROGRAMMING
is displayed.
3. Press the “P” key. ENTER CODE will be displayed.
4. Using the recipe keys, type 3228.
5. Press the “P” key. Display will show SYSTEM.
6. Press the down arrow key until FACTORY is
displayed.
7. Press the “P” key. MAX PROG TEMP will be
displayed, then either 550F or 500F.
8. Use the Right or Left arrow keys to change the
setting to either 550F or 500F.
9. Press the “P” key. FAN SPEED TYPE will be
displayed, then either 1 SPEED or 2 SPED.
10. To change the setting, use the Right or Left
arrow keys.
11. Press the “P” key. FACTORY will be displayed.
12. To exit factory programming press the Up key
twice or until EXIT is displayed.
13. Press the “P” key to exit.
To Next Page
Loading...
