2-7
Chapter 2 Basic Operation
F side B side
7
Move the clincher according to the scale
on the label.
When moving the clincher, hold each side of
the clincher.
Align the edge of the clincher on the
operator’s side with the scale.
”Stapling position” (p.2-9)
Binding
mode
Paper width Mark on label
(stapling
width)
Saddle
staple,
Corner staple
(option)
Less than 180 mm
/7.09 inches
1* (70 mm
/2.76 inches)
180 mm/
7.09 inches to
less than 252 mm
/9.92 inches
2 (108 mm/
4.25 inches)
252 mm/
9.92 inches or
more
3 (160 mm
/6.30 inches)
Side staple
(option)
LTR (279.4 mm
/11 inches)
4 (258 mm
/10.16 inches)
A4 (297 mm
/11.69 inches)
5 (276 mm
/10.87 inches)
* ”1” is not for side-stapling.
8
Using the supplied hexagonal wrench,
tighten the clincher fixing screws.
After using the hexagonal wrench, be sure
to put it back in the hexagonal wrench
holder.
(p.1-6)
9
Attach each stapler unit according to
the scale on the label.
The stapling width varies depending on the
paper size.
”Stapling position” (p.2-9)
Binding
mode
Paper width Mark on label
(stapling
width)
Saddle
staple,
Corner staple
(option)
Less than 180 mm
/7.09 inches
1* (70 mm
/2.76 inches)
180 mm/
7.09 inches to
less than 252 mm
/9.92 inches
2 (108 mm/
4.25 inches)
252 mm/
9.92 inches or
more
3 (160 mm
/6.30 inches)
To Next Page
Loading...