- 19 -
Paper feed
direction
４.Paper Handling
● Flatten paper with folds or wrinkle or curls before using.
● Completely dry print ink on the paper before using.
CAUTION
Using paper with print ink not dried completely will stain fold roller and this will cause
trouble such as stain on the paper.
● Use paper cut precisely.
WARNING
If the squareness of the paper is not precisely, this will cause trouble such as
fold skew.
● Fully fan papers when right after copied or printed.
WARNING
Paper right after copied or printed contains
much static electricity.
If the papers are not fully fanned, this will
cause trouble such as double feed.
When the paper is set to the manual slot of the DC-SC1, please confirm the right side/other side
and leading edge/rear edge of the paper.
When confirming the finish after test fold, check fold skew and the right side/other side and leading
edge/rear edge of the paper.
[ Example] When the paper (right side: colored, other side: white) is folded by the fold mode
as below.
V-fold has 2 directions to be folded (1V-fold and 2V-fold). When 1V-fold is selected, the paper is
folded as shown above. When 2V-fold is selected, it is folded in reverse direction. (Refer to 1-1.
Fold type on page 28.)
4-2.Confirming right side/other side and leading
edge/rear edge of paper
Paper set to manual slot
Half fold
(V-fold)
To Next Page
Loading...
Need help?
General
