7. Switching Input Unit
You can select input unit, mm mode or inch mode. This section describes the procedures to
switch it from mm mode to inch mode. Default setting of input unit is mm mode.
1．Confirm that the LCD panel displays stand-by
screen.
Right illustration: JOB No. which JOB is not
registered is displayed as
‘No Data’.
2．Press the F key to display the ‘Select menu’
screen on the LCD panel.
3. Press the CURSOR key (Down) several times
to select ‘Settings’.
4. Press the SET key to fix ‘Settings’.
Select menu
Retrieve JOB
Enter JOB
Settings
7-1. Selecting input unit
To Next Page
Loading...
