32
12. CONNECTING THE DOWNSTREAM UNIT
Paper conveyed to the downstream unit when paper feed error occurs (no paper, mis feed, double-feed,
etc.) will be ejected without binding. In this case, operations of the DFC-12/10 can be stopped or contin-
ued according to preference. At shipment, “Error paper ejection” is set to “Stoppage”.
1
Press the key and display
"On-line setting".
Press the key and display the
screen for selecting "Booklet
maker", "Trimmer", and "Error paper
ejection".
Press the key to display the "Er-
ror paper ejection" screen, and next press
the
key to display the after clearing
screen.
2
3
Press the key to display the
screen for selecting whether to con-
tinue or stop operations after ejec-
tion.
Press the key to display the
screen where the operation to be set is
blinking.
4
Press the key and save the op-
eration selected at step 3.
To redo the setting, press the key an-
other time to return to step 3.
5
Press the key to return to the
standby screen.
Press the key until the standby screen
is displayed.
Setting "After clearing paper feed error"
Note • Even though “Continuation” is selected,
operations stop when feeding errors oc-
cur twice successively. In case of high
speed, another set may be fed after those
erroneous sets. This set will be, however,
ejected without binding.
• When On-line setting is set to “Through”,
any error stops operations even though
“Continuation” is selected.
• If errors (empty-feed, double-feed, ) oc-
cur for the last set in collation when the
count display method is set to "count-
down method", the machine will stop
when count is 1 even though "Continua-
tion" is selected.
To Next Page
Loading...
Need help?
General
