Duplo DUPRINTER DP-440 - Page 245

247
c HELP Mode Function and Operation Procedures
chap.7
ABCD Item Setting
0000
Set amount
Standard (initial value)
Maximum
0001
0010
0011
•
•
•
•
•
1111
1 rank: 0.25%
ePress the [=] key.
The correction amount will be memorized in the battery PCB unit's
EEPROM. During memorization,"SAVE" will be displayed.
Do not turn off the power before the "SAVE" display has disappeared.
1. Functions
(1)
Scan R/E /line progression direction setting (ADF)
¡ Adjust the scan R/E /line progression direction of ADF with H-25 if
it cannot be corrected with H-24.
(1) Scan R/E /line progression direction setting (ADF)
H-25
(1) Adjustment / specification settingHELP mode
¡During memorization:
IMPORTANT :
2. Operation procedure
Accessing HELP modes
a See page 213
qAccess HELP mode H-25, and press the PRINT key.
HELP-025
Adjustment
1111
wUse the [0] and [1] numeric keys to enter a 4-place binary
value for the desired correction amount.
See the table below for 4-place binary values and the corresponding
correction amounts.
a To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
rPress the STOP key.
The HELP mode selection display will reappear.
A B C D
- SAVE -