Duplo DUPRINTER DP-440 - Page 279

281
c HELP Mode Function and Operation Procedures
chap.7
H-66
(1) Adjustment / specification settingHELP mode
ABCD Item Setting
0***
OFF
1***
*0**
*1**
A3
A4
*10*
*11*
***0
A3/A4 drum setting
***1
1100
Factory setting
Signal sensor setting
Paper feed sensor
(loop sensor) setting
Long Mode setting
ON
OFF
ON
OFF
ON
Mode H-65 is not used.
ePress the [=] key.
The correction amount will be memorized in the battery PCB unit's
EEPROM. During memorization,"SAVE" will be displayed.
Do not turn off the power before the "SAVE" display has disappeared.
1. Functions
(1)
Signal sensor ON/OFF, Loop sensor ON/OFF, A3/A4 drum,
Long Mode setting
¡Following items are indicated.
A : Signal sensor ON/OFF
B : Loop sensor ON/OFF
C : A3/A4 drum
D : Long Mode ON/OFF
(1) Signal sensor ON/OFF, Loop sensor ON/OFF, A3/A4 drum,
Long Mode setting
¡During memorization:
IMPORTANT :
2. Operation procedure
Accessing HELP modes
a See page 213
qAccess HELP mode H-66, and press the PRINT key.
HELP-066
Spec setting
1100
wUse the [0] and [1] numeric keys to enter a 4-place binary
value for the desired correction amount.
See the table below for 4-place binary values and the corresponding
correction amounts.
a To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
rPress the STOP key.
The HELP mode selection display will reappear.
A B C D
- SAVE -