DURKOPP ADLER 512 - Page 56

Settings via the software
Operating Manual 512/532 Version 00.0 - 12/201354
E 3 0 2 Supper section
error
Upper section is tilted over. • Tilt the upper section
back into place.
E 3 0 5 Thread cutter
position error
Thread cutter knife not in the
home position
• Main power switch OFF.
• Check the sensor.
E 3 0 6 Thread catcher
position error
Thread catcher not in the
home position
• Main power switch OFF.
• Check the sensor.
E 3 3 2 Clamp foot
position error
Clamp foot not in the home
position
• Main power switch OFF.
• Check the sensor.
E 5 0 1 Data read error Data not present or stored in
the wrong format
• Store the data anew on
the USB stick.
E 5 0 2 USB read error MOT file faulty • Store the data anew on
the USB stick.
E 5 0 3 SUM read error CHECKSUM data in MOT
file faulty
• Store the CHECKSUM
file anew on the USB
stick.
E 5 0 4 Endblock error No Endblock in the MOT file • Store the Endblock file
anew on the USB stick.
E 5 0 5 USB read error USB stick not found • Main power switch OFF.
• Main power switch ON.
• Plug in the USB stick
again.
E 5 0 6 USB read error Reading from U01 ~ U10 not
possible.
• Main power switch OFF.
• Main power switch ON.
• Plug in the USB stick
again.
E 5 0 7 Own seam
appearances
read error
Read error U01 ~ U10 • Download data again.
E 5 0 8 Own seam
appearances file
error
Read error U01 ~ U10 • Check the file type.
E 5 0 9 Own seam
appearances file
error
Read error U01 ~ U10 • Check the file type.
Error message Description Possible cause Remedy