DURKOPP ADLER 512 - Page 57

Settings via the software
Operating Manual 512/532 Version 00.0 - 12/2013 55
E 5 1 0 Own seam
appearances file
error
Read error U01 ~ U10 • Check the file type.
• Store the data anew on
the USB stick.
E 5 1 1 USB write error File with the same name
already present
• Delete or rename the file.
E 5 1 2 USB read error Data cannot be loaded from
the USB stick
• Check the USB stick.
• Plug in the USB stick
again.
E 5 1 3 USB write error Data cannot be copied to the
USB stick.
• Check the USB stick.
• Plug in the USB stick
again.
E 5 5 0 Data write error Flash memory transfer error • Main power switch OFF.
• Repeat the procedure.
• Replace the mainboard.
E 5 5 1 Internal process
error
Software error • Main power switch OFF.
• Repeat the procedure.
• Replace the mainboard.
• Replace the software.
E7
7
0
3
7
5
Motor signal
error
Encoder / motor has no
signal
• Check the motor /
encoder.
E 7 3 6 Motor rotation
error
Motor stops after a certain
time / encoder has no signal
• Check the motor /
encoder.
E 7 3 7 Z phase error Z signal no longer changes • Check the motor /
encoder.
E 7 3 8 Z phase error Z signal inaccurate / encoder
has no signal
• Check the motor /
encoder.
E 9 0 7 X axis search
error
X axis sensor not responding • Main power switch OFF.
• Check the sensor.
E 9 0 8 Y axis search
error
Y axis sensor not responding • Main power switch OFF.
• Check the sensor.
E 9 1 0 Clamp foot
search error
Clamp foot sensor not
responding
• Main power switch OFF.
• Check the sensor.
E 9 1 1 Clamp foot
motor error
Clamp foot motor not
running correctly
• Main power switch OFF.
• Check the motor and
connections.
Error message Description Possible cause Remedy