Light barriers
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 119
Checking the light barrier position with the folder swiveled in
Fig. 101: Checking the light barrier position with the folder swiveled in
To check the light barrier position with the folder swiveled in:
1. Slide the transport clamps to the rear position.
2. Press the button.
The folder is depressurized.
3. Manually press the folder onto the sliding plate.
4. Pull the transport clamps forward.
The folder sole is guided under the folding plates.
5. Check the switching behavior of the light barriers with the folder
swiveled in.
6. Swing the folding station (1) back out.
7. Remove the strips of adhesive tape from the reflecting foils.
Information
If the light barriers fail to switch at seam beginning and seam end, check
if the transport clamps are parallel and adjust them ( p. 86).
NOTICE
Property damage may occur!
Risk of breakage.
The folding station must be swung out again after the light barriers
have been set.
(1) - Folding station
To Next Page
Loading...
