Programming
170 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
1.25 Toolbox configuration p. 244
Hook thread monitor On/Off p. 238
Tape feeder On/Off (745-35-10 B only) p. 238
Vacuum On/Off p. 238
Downholder On/Off p. 238
Waistband clamp On/Off (745-35-10 A only) p. 238
Roll-off On/Off (745-35-10 A only) p. 238
Split needle bar On/Off (745-35-10 A only) p. 239
2.0 Machine test
2.1 Test hook thread monitor p. 252
2.2 Test roll-off device p. 253
2.3 Align light barriers p. 254
2.4 Adjust corner knife p. 256
2.5 Switch on needle + middle knife p. 250
2.6 Test tape feeder (745-35-10 A) p. 251
2.10 Test step motor p. 263
2.11 Adjust and test control panel p. 265
USB_Logging p. 251
Machine workflow test p. 259
Loading process test p. 260
Test step by step p. 261
Test cycle time p. 262
3.0 Multi test
3.3 Internal devices p. 278
3.4 External devices p. 280
3.5 Multi test I/O p. 274
3.6 Sewing motor test p. 282
3.7 Error messages p. 273
RAM test p. 279
ROM test p. 281
Menu item
Option/described
on page
To Next Page
Loading...
