Troubleshooting
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 323
8411 Information Machine is checking new program. This process can take up to 30 sec.
8414 Information Update completed!
8415 Information Continue with old software. (If you use the old software, we cannot
guarantee that all functions will be available to the full extent.)
Error code 9000-9999: Error messages displays
9000 Reminder to execute the
reference run after switching on
Press the left pedal backwards
9001 Corner knife station swiveled out
during sewing
Check/set fastening of corner knife
station
9002 Folding station swiveled out
during sewing
Check/set fastening of folding
station
9003 Wrong needle position Manually turn the handwheel to the
upper position of the thread lever
(top dead center)
9007 Test the loading process Resuming the process after pushing
the start pedal
9013 Tape missing Insert tape
9014 Position of transport clamp
doesn't match the installed die
Correct position of transport clamp
in the seam parameters
p. 221
9015 Wrong adjustment of flap
scanning in the seam program
Correct seam program
9501 Test step by step Use pedal for progress
9601 Pedal was pressed backwards
during sewing
Press pedal again
9604 Light barrier for sewing material
removal not active
Set light barrier for sewing material
removal
9605 Transport clamp moves
9700 Folder not up Correct folder setting
9701 Folder not down Correct folder setting
9702 Folder not vertical Correct folder setting
Error code Symbol Meaning Remedial action
To Next Page
Loading...
