4.3 Fitting the belt guards
–
Disassembly the hand wheel (1).
–
In the machines with the motor on the table top mount the guard (2)
on the machine head (the guard is included in the set of parts for
motor) and mount the guard (3) on the motor (the guard is included
in the motor package).
–
In the machines with the motor on the machine head mount the
guard (4) (is included in the s et of parts for motor).
–
Mount the hand wheel (1). Doing this, observe the correct angle
position: if the needle is in the upper dead point, there should be
the 0° value on the hand wheel scale.
10
1
2
3
1
4
To Next Page
Loading...
