4.6 Fitting the proximity switch
–
The proximity switch (1) is mounted to certain positioning motors
(drives) only. In that case it is part of the drive supply.
–
Slide the proximity switch (1) in the arrow (2) direction on the hand
wheel shaft so that the carrier pin (3) fits in the proximity switch
groove.
–
Attach the proximity switch with two screws (4).
–
Remove the back cover and pull the proximity switch cable (5)
through according to the picture.
–
Attachthecablewithaclip(6).
13
GB
2 1 4
3
5
6
To Next Page
Loading...
