EasyManuals Logo

DURKOPP ADLER 887 User Manual

DURKOPP ADLER 887
61 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
6.2.5 Checking of set positions
1st position
Switch on the network switch.
Tr ead the pedal forwards shortly and release. The machine is
stopped in the 1
st
position. (see chapter 6.2.1).
Check the angle on the hand wheel scale (225° ± 5°).
2nd position
Tr ead the pedal forwards shortly at first and then entirely
backwards with the heel until the machine stops. The machine
stops in the 2
nd
position. (see chapter 6.2.1).
Check the angle on the hand wheel scale (55° ± or 35° ± 5°).
6.3 Master reset
By means of the so-called master-reset all changed values are set
back to the preset ones again.
7. Lubrication
Before start, the machine must be lubricated properly with oil
according to chapter 11.2 in the first part (operating instructions).
8. Sewing test
This test can be carried out only after the machine is set completely.
Thread in the bobbin-winder thread (see operating instructions).
Turn on the main switch.
Lock the sewing foot in the lifted position (see operating
instructions).
Fill the bobbin at low speed.
Turn off the main switch.
Thread in needle thread and bobbin thread (see operating
instructions).
Select the material to be sewn.
Carry out the sewing test first at low speed and then gradually
increase the speed.
Check whether the seams are of the desired quality.
If the quality requirements are not met change the thread tensions
(see operating instructions).
25
GB

Table of Contents

Other manuals for DURKOPP ADLER 887

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DURKOPP ADLER 887 and is the answer not in the manual?

DURKOPP ADLER 887 Specifications

General IconGeneral
BrandDURKOPP ADLER
Model887
CategorySewing Machine
LanguageEnglish

Related product manuals