(a) Trace
The Trace processing function allows the user to read out values of the on-
screen spectrum by means of the crosshair “+” cursor. On completion of
measurement, press <1> on the keyboard and then the trace screen appears as
shown below.
11/11/02 10:41 600.0 nm 0.854 ABS
Time Scan
1.000
ABS
0.000
06
0s
Trace :S 12 ABS 0.031
When the crosshair (+) cursor appears on the spectral graph, it can be moved
left/right using the arrow keys. Holding the arrow key down causes this cursor
to move quickly. The time and photometric value pointed by the cursor are read
out and indicated at the bottom of screen.
(b) Peaks
The Peaks processing function allows the user to detect spectral peaks. On
completion of measurement, press <2> and then the peaks screen is presented as
shown below.
3-40
To Next Page
Loading...
