Press the number key on the keyboard to select corresponding function.
rinter setup: DB-20 support three types of printer, namely ESC/P, PCL3 type
. System Setup (refer to section 3.3)
Press <5> to select System Setup from the Multiple WL submenu, a submenu
Lamp Change Mode:
three Lamp Change Mode are available.
p and
nly: Using D2 lamp over the entire wavelength
p Only: Using WI lamp over the entire wavelength
Lamp Change WL (nm):
sed for selection of light source switching
hotometer is provided with WI lamp for visible
P
and Seiko thermal printer.
5
list appears on the right side of the screen as shown in the illustration below:
11/13/02 11:35 600.0 nm 0.854 ABS
Multiple WL
1 Parameter Setup 1 Auto
2 Sample Setup 2 Lamp Change WL (nm) 350.0
3 Curve Setup 3 WI Lamp On
4 Print Setup 4 D2 Lamp On
5 System Setup
6 Save Parameter
7 User Baseline
0 Forward
Select Function: _
Lamp Change Mode
1 Auto 2 D2 Only 3 WI Only
The followings
Auto: Changeover is automatically made between D2 Lam
WI Lamp.
D2 Lamp O
region.
WI Lam
region.
This parameter is u
wavelength.
This spectrop
range measurement and D2 lamp for ultraviolet range
3-52
To Next Page
Loading...
