Curve Type: Select the required curve types.
a) 1st order
b) 2nd order
c) Segment
d) K – factor
Press corresponding key on the keyboard to select curve type. For “1st order”,
the standards number should be more than 2. For “Second order”, the standards
number should be more than 3. For “K-factor”, value of k
0
, k
1
and k
2
need to be
input
manually.
Note: If the standards number is not fit the curve type, the system will
automatically changed the numbers to fit the curve type.
Curve Data: Input the standards concentration. Press <2> on the
keyboard to input the standard Curve Data.
STD NUM: (Number of standards)
Select the numbers of standards sample between “1” to “20”.
4. Print Setup (refer to section 3.3)
Press <4> to select Print Setup from the Multiple WL submenu, a submenu list
appears on the right side of the screen as shown in the illustration below:
1 ESC/P 2 DPU 3 PCL3
11/13/02 11:35 600.0 nm 0.854 ABS
Multiple WL
1 Parameter Setup 1 Printer Type ESC/P
2 Sample Setup
3 Curve Setup
4 Print Setup
5 System Setup
6 Save Parameter
7 User Baseline
0 Forward
Select Function: _
3-51
To Next Page
Loading...
