Dynamica HALO DB-20 - Page 91

2. Sample Setup(refer to section 3.3)
When selecting the Sample Setup, the Sample Setup screen appears on the LCD
as shown below.
11/13/02 9:54 600.0 nm 0.854 ABS
Multiple WL
1 Parameter Setup 1Name SAMP-1
2 Sample Setup 2 Path Length (nm) 10.0
3 Curve Setup 3 Unit Label MG/L
4 Print Setup
5 System Setup
6 Save Parameter
7 User Baseline
0 Forward
Input Value:_
3. Curve Setup (refer to section 3.3)
Press <3> key to select Curve Setup from the Multiple WL submenu. A
submenu list appears on the right side of the screen, four options are available.
1 1st Order 2 Second Order 3 Segment 4 K-factor
10/11/02 14:28 600.0 nm 0.854 ABS
Multiple WL
1 Parameter Setup 1 Curve Type 1st order
2 Sample Setup 2 STD NUM 3
3 Curve Setup 3 Curve Data
4 Print Setup 4 Repeat NUM 2
5 System Setup 5 Hi Limit 9999
6 Save Parameter 6 LO Limit 0
7 User Baseline
0 Forward
Select Function: _
3-50