Eaton® 9390 (100–160 kVA) UPS Installation and Operation Manual 164201604—Rev F 50
88..11 UUssiinngg tthhee LLCCDD aanndd PPuusshhbbuuttttoonnss
The LCD on the control panel provides an operator interface with the UPS system. Figure 18 identifies the
display areas discussed in the following sections.
FFiigguurree 1188.. PPaarrttss ooff tthhee LLCCDD
METERS PUTESSTNEVE
ALARM: INPUT AC UNDER VOLTAGE
OUTPUT
BATT
UPS
INPUT
STSW
A
B
C
D
CONTROLS LOAD OFF
BYPASS
AA The UPS status area automatically scrolls between the Eaton model number, current date and time, active
alarms, active notices, and load percent and battery runtime for the UPS. Shown is a typical alarm message.
For more information about alarms and notices, see Chapter 11 Responding to System Events.
BB The information area contains data about UPS status and operations.
CC The menu bar lists the titles of the available screens. To select a screen, press the pushbutton underneath
the desired screen.
DD The navigation pushbuttons functions depend on the screen displayed. Use the pushbuttons to select menu
screens or scroll through available screens. The LCD options above the pushbuttons indicate each
pushbutton's function.
You can use the LCD and the pushbuttons to:
• Look at a log of UPS events (alarms, notices, and commands) (see 8.2.2 Event Screens)
• Monitor UPS operation (see 8.2.3 Unit Meter Screens)
• Set UPS parameters (see 8.2.8 System Setup Level 0 Screens and 8.2.9 System Setup Level 1 Screens)
• Control UPS operation (see 8.3 System Controls Screen)
After approximately 30 minutes, the display screen darkens. To restore the screen, press any pushbutton once.
Using the Control Panel
To Next Page
Loading...
