Eaton 93PM - Minislot Interface Connections

To Next Page

To Previous Page

1. Make sure that the ancillary equipment system is turned off and all the

power sources are removed. Refer to the appropriate operation manual of

any ancillary equipment for shutdown instructions.

2. Install wiring from the IRC to the monitoring equipment using appropriate

conduits through the cable exit opening in the IRC.

3. Connect wiring between the IRC terminal blocks and the monitoring

equipment using terminations. Connect one wire to COM (Common) and

another to either NC or NO to select the Normally Open or Normally Closed

option.

4. Install the INDRELAY-MS into an open MiniSlot communication bay in the

UPS cabinet.

Figure 27. Industrial Relay Card INDRELAY-MS

5.6.5 MiniSlot interface connections

For MiniSlot accessories and communication devices selection, see Chapter

For installation and setup of a MiniSlot card, please contact your Eaton

representative.

To install wiring to the connections:

1. If not already installed, install the LAN drops.

2. Open the front door of the UPS.

3. To remove the MiniSlot cover plate, remove the 2 screws securing the

plate.

4. To install the MiniSlot communication device, push it all the way in.

5. Secure the MiniSlot communication device with 2 screws.

6. Route and install the LAN and other cables to the appropriate MiniSlot

cards. The cable route is through the signal cable canal in the top section

of the UPS.

7. For operator instructions, refer to the manual supplied with the MiniSlot

card.

Eaton 93PM UPS 30–200 kVA

User's and installation guide

Other manuals for Eaton 93PM