Setting Description
Signal Input Select signal input name and function or change contact polarity.
Relay Outputs Configure the relay outputs.
Battery test Change the power level and duration for battery test.
Bypass Limits Change the bypass voltage or bypass frequency.
Screen Saver Time-
out
Change the screen saver timeout.
Meters Change the meters format.
Lamp Test Enable the lamp test.
HMI backlight Adjust the backlight brightness.
Control P/W level 1 Change the level 1 password, or remove the password on level 1.
The default value is 1111.
Control P/W level 2 Change the level 2 password. The default value is 1010.
Reset statistics Reset all statistics.
Minimum required
kVa
Change the minimum required kVa.
7.2 Signing in
If the level 1 password is enabled, you need to sign in.
1. Press the lock icon in the top right corner of the screen.
2. Type in your password and press OK.
You are signed in.
3. Press Continue to return to the previous screen.
You have 3 attempts to type in the password. If an incorrect password is given
more than 3 times, you need to wait for 30 minutes before trying again.
Table 22: Default passwords
Level Name Password Description
0 USER NONE USER
1 CONTROL 1111 USER + CONTROL
2 CONFIGURA-
TION
0101 USER + CONTROL + CONFIGU-
RATION
3 SERVICE Service Only USER + CONTROL + CONFIGU-
RATION + SERVICE
To modify the user settings, you need to enter the level 2 password.
Eaton 93PM UPS 30–200 kVA
User's and installation guide
©
Eaton Corporation plc 2017. All rights reserved. Revision: 005 Document ID: P-164000249 95 (126)
To Next Page
Loading...
