107
EA(B)O-6X06 01/2018 Rev. 1 3. Disassembly and Assembly
50. Install the TCU upper and lower brackets assembly,
securing the lower bracket to the transmission rear case
ange with two retaining screws.
6946
51. Install the third retaining screw securing the TCU lower
bracket together with one end of the ground strap.
48. With a 13mm open-end wrench, install the clutch
actuator cylinder hydraulic tube (1).
49. Install the clutch actuator position sensor (2) with the
two retaining screws and connect the wire harness.
Transmission Assembly
6947
6950
1
2
6910
To Next Page
Loading...
