Maintenance and Alarms
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 132
Figure 79. System Settings Page
9. From the Open window, select the Imag
e<xxx>.bin file, and click Open.
10. In the Network Management Card panel, click Upgr
ade Network Management Card to launch the
upload. A progress bar shows the progress of the update.
Do not disturb the upgrade until the progress bar shows complete.
11. When finished, a message displays and the communications module restarts automatically. The upgrade
takes four to five minutes. When the upgrade completes, refresh the Web pages.
Upgrade the Firmware and Refresh Web Pages
After the binary file is uploaded to the communications module, the final step is an automatic process that
upgrades the firmware and refreshes the Web pages.
To Next Page
Loading...
