Maintenance and Alarms
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 131
Uploading the Binary File
To access the Web interface:
1. Ensure that an Ethernet cable is correctly connecte
d between a Windows PC and the Ethernet port on the
ePDU. Verify communication.
2. Start up the ePDU and note the IP address displayed on the LCD.
3. Open the Web browser and type the IP address you obtained from the ePDU.
4. When the connection is made, the Authentication dialog displays.
5. Enter a valid user name and password in the authentication dialog box (see Figure 78). Click Login to
continue or Cancel to exit.
NOTE The default user name is “admin” and the default password is “admin.”
Figure 78. Login Authentication
6. The ePDU Overview page displays.
7. From the menu bar, click Settings and then System. The System Settings page displays in the Main
Appl
ication window (see Figure 79).
8. In the Network Management Card panel, check Firmware upgrade enabled and click Browse to find the
upgrade file.
To Next Page
Loading...
