Front Section
62
3. Install the 2nd speed synchronizer rings, inner,
middle and outer, in this order. Make sure they
are installed in the proper position. The inner ring
lugs must be facing to the synchronizer hub while
the middle ring lugs must t into the holes in the
gear cone. Refer to “Synchronizer Assemblies”
later in this manual.
4. Install the 1st/2nd speed synchronizer assembly.
Make sure it is installed in the proper position.
WARNING! Both the largest chamfer of the
synchronizer sleeve and the most protruding side
of the hub of the 1st/2nd speed synchronizer must
face the 1st speed gear (refer to “Synchronizer
Assemblies”).
426
429
438
427
430
439
5. Align the center of the recess in the synchronizer
sleeve teeth with the center of the key at the
three positions and install the synchronizer
sleeve.
6. Install the 1st speed outer and middle
synchronizer rings. Make sure they are installed
in the proper position. Refer to “Synchronizer
Assemblies” later in this manual.
7. Install the 1st speed inner synchronizer ring.
Make sure ring lugs t into the hub slots.
448
441
454
352
451
To Next Page
Loading...
