Front Section
Front Section
63
8. Install the 1st speed gear, tting the holes in the
gear cone on the middle synchronizer ring lugs.
9. Install the 1st speed gear needle bearing.
10. Install the 1st speed gear bushing.
11. Install the rear bearing cone on the mainshaft.
459
465
470
474
12. Using the E010002 special tool, press the late
installed set of components onto the mainshaft.
Make sure to align the synchronizer ring lugs with
hub key slots to properly t.
WARNING! Apply force to bearing inner race.
NEVER apply force to the bearing cage. Do NOT
use the shaft ange as a pressing base.
13. Check if the pressing procedure has been
successful: disengage the synchronizer and put it
in an intermediate position between 1st and 2nd
speed gears. The gears in this condition should
rotate freely.
14. Turn the mainshaft over and install the 3rd speed
gear needle bearing.
15. Install the 3rd speed gear.
477
483
486
To Next Page
Loading...
