Eaton Fuller FSO-2405 - Page 104

104
Rear Section Assembly
3
Rear Section 2nd Ed. 02/07 FSO-2405
FSO-2405/13
18
FSO-2405/15
16
FSO-2405/99
15
15. If necessary, replace the 5th/reverse shift yoke
nylon pads.
16. Install the 5th/reverse shift yoke in
synchronizer sleeve groove. Pull the yoke
backwards until engaging with the linked shift
block.
17. Install the two pivot threaded pins of 5th/reverse
shift yoke.
NOTE: Apply Eaton E677 sealant to the
pin threads.
Torque = 10-16 N.m (7-12 Lb.ft)
NOTE: See “Special Tools”, Ref. E001044.
18. Install the reverse gear spacer and the two
needle bearings on the countershaft.
NOTE: The reverse gear needle bearing on
the countershaft was updated. When
servicing the unit, if older, replace both
bearings (p/n 3342286) and spacer (p/n
3342287) by the new lone bearing (p/n
3348906).
FSO-2405/14
17
17