103
Rear Section Assembly
3
FSO-2405 2nd Ed. 02/07 Rear Section
FSO-2405/18
FSO-2405/17
12
11
FSO-2405/19
10
FSO-2405/16
14 13
10. Install the 5th speed gear on the countershaft.
11. Install the 5th speed ring synchronizer on the
countershaft.
NOTE: The 5th speed synchronizer ring is
not coated with EFM II and is smaller than
the other rings.
12. Install the 5th/reverse synchronizer assembly
on the countershaft. Make sure it is installed in
the proper position.
WARNING! Both the synchronizer sleeve
sharp end and the hub anti-escape relief
should be installed facing the 5th speed
gear (see “Synchronizer Assemblies”).
Make sure to slide the synchronizer ring
lugs into the hub key slots.
13. Install the 5th/reverse synchronizer hub snap
ring on the countershaft.
14. Install the reverse synchronizer ring.
NOTE: The reverse synchronizer ring is
coated with EFM II and is smaller than the
other rings.
To Next Page
Loading...