Eaton Fuller FSO-2405 - Page 109

109
Rear Section Assembly
3
FSO-2405 2nd Ed. 02/07 Rear Section
FSO-2405/2
38
37
42
41
40
FSO-2405/1
37. Install the speedometer rotor.
38. Install the rotor retaining snap ring.
39. Apply sealant compound gasket to the rear
cover mounting surface with the intermediate
housing.
NOTE: Apply Eaton E680 sealant to the
mounting surface.
40. Install the rear cover.
41. Install the thirteen retaining capscrews of rear
case to the intermediate housing. Tighten the
capscrews crosswise to the proper torque.
NOTE: Apply Eaton E677 sealant to
th e capscrews.
Torque = 19-25 N.m (14-19 lb.ft)
42. Install the speedometer sensor.
NOTE: Apply Eaton E680 or Eaton E679
sealant to the sensor thread.
Torque = 10-16 N.m (7-12 lb.ft)