Eaton Fuller FSO-2405 - Page 108

108
Rear Section Assembly
3
Rear Section 2nd Ed. 02/07 FSO-2405
FSO-2405/3
36
FSO-2405/100
35
29. Remove the special tool from the mainshaft.
30. Install the rear nut on the mainshaft.
NOTE: When installing the nut, replace the
used nut by a new one.
31. Place the tool to tighten the mainshaft rear nut.
NOTE: See “Special Tools”, Ref. E006006.
NOTE: As an option, the tool # E006004 or
# E006005 may be used for installing the
mainshaft rear nut, locking the mainshaft
with the tool # E006003. See “Special Tools,
Using the Eaton tool # E006003”.
32. Place the special tool and lock the mainshaft.
NOTE: See “Special Tools”, Ref. E014010.
33. Tighten the mainshaft rear nut to the proper
torque.
NOTE: Torque = 217-270 N.m (160-200 lb.ft)
34. Remove the tools.
36. Install the retaining ball that locks the
speedometer rotor in the mainshaft. Apply
grease to hold the ball in place.
FSO-2405/156
31
32
35. Use a punch and lock both the mainshaft and
countershaft rear nuts.