107
Rear Section Assembly
3
FSO-2405 2nd Ed. 02/07 Rear Section
FSO-2405/141
FSO-2405/138
25
26
25. Use the recommended tool and install the rear
ball bearing on the countershaft.
NOTE: See “Special Tools”, Ref. E010001.
26. Use the recommended tool and install the rear
ball bearing on the mainshaft.
NOTE: See “Special Tools”, Ref. E010002.
FSO-2405/5
27
28
27. Lock the mainshaft with the special tool and shift
transmission into the 1st gear.
NOTE: See “Special Tools”, Ref. E014010.
NOTE: As an option, the tool # E006003 may
be used for locking the mainshaft. See
“Special Tools, Using the Eaton tool #
E006003”.
28. Install the rear nut (or snap ring) on counter-
shaft and tighten to the proper torque.
NOTE: On 2006, the nut was replaced by a
snap ring in some applications.
NOTA:
See “Special Tools”, Ref.
E006002.
Torque = 108-122 N.m (80-90 lb.ft)
NOTE: When installing the nut (or the snap
ring), replace the used nut (or used snap
ring) by a new one.
To Next Page
Loading...