22 Eaton PDI WaveStar BCMS Hub Installation and Operation Manual P-164001108—Rev 01
44..11..33 IInniittiiaall AAddmmiinniissttrraattoorr AAcccceessss
To initially set up BCMS Hub users, Eaton provides a temporary Administrator PIN and password. The initial
PIN.password is 100.23223. The administrator should:
1. Log in on the Home screen.
2. Navigate to the Users screen.
3. Change the administrator PIN and password and then keep them secure.
4. Set up each user’s security information as described in the following sections.
After initial startup, commissioning, testing, or restart, the administrator should clear any alarms that occurred.
Alarms must be separately cleared on each device that has alarms.
44..11..44 UUsseerrss SSccrreeeenn
Figure 15. Users Screen
Touch the User button at the bottom of a display screen to display the Users Screen (Figure 15).
The Users screen
• lets the Administrator set up new users and their level of access to the BCMS Hub, and
• displays the names of registered users and unassigned slots.
Scroll through the user list using the scroll bar on the right side of the screen to highlight a user name.
Set up or modify a user’s profile using the Name, PIN, Password, and Class buttons. Each user must be
assigned a password and PIN.
• The Administrator sets a user’s access class by touching the Class button and entering the first letter of
the class:
System Setup
To Next Page
Loading...
