For more information visit: www.eatonelectrical.com RP01400001E
Renewal Parts
Page 42 Effective: February 2009
Current Cutler-Hammer
Panelboards
Pow-R-Command
For replacement parts, see PRL3a
Section, Page 21. Parts available are
the following:
■ Connector kits.
■ Ground assemblies.
■ Service entrance kits.
■ Deadfront covers.
■ Trim locks.
Pow-R-Command
Additional Services
Since virtually all panelboards are
supplied to meet specific customer
requirements, other parts not listed in
this publication might occasionally be
needed. Price and availability for parts
not shown here may be obtained by
contacting your local Satellite plant
and providing a complete description
of the part along with the data on the
panelboard nameplate.
Should you experience difficulty in
determining what replacement parts
are needed, contact your local Satellite
Plant Manager who can provide help to:
■ Identify and recommend
replacement parts.
■ Remove damaged parts and
instruct you in how to install
replacement parts.
■ Verify the correct connector kits
which should be ordered for each
circuit breaker or fusible switch.
■ Retrofit existing panelboard boxes
with new Pow-R-Line interiors.
■ Provide a recommended spare
parts list.
National Electrical Code and NEC are
registered trademarks of the National
Fire Protection Association, Quincy,
Mass. NEMA is the
registered trade-
mark and service mark of the National
Electrical
Manufacturers Association.
UL is a federally registered
trademark
of Underwriters Laboratories Inc.
To Next Page
Loading...
