Eaton Pow-R-Line SPX0370245 - Using Configuration Mode

www.eaton.com IM02601001E 6-5
Using the PXM 2000 Series

 follows Reset: Energy on the Main Menu.
To access :
1. Press the Menu button while the meter is auto-scrolling parameters.
2. Press the Down button until the Conguration Mode option () is in the A window.
3. Press the Enter button. The  screen appears.
4. Press the Down button to scroll through the conguration parameters: , CT, PT, Connection
 and Port. The parameter currently ‘Active,” i.e., congurable, ashes in the A window.
5. Press the Enter button to access the Setting screen for the currently active parameter.
: 

Press Enter when CFG is in A window - Parameter screen appears - Press Down-
Press Enter when Parameter you want is in A window
6. The parameter screen appears, showing the current settings. To change the settings:
• Use either the Down button or the Right button to select an option.
• To enter a number value, use the Down button to select the number value for a digit and the Right button
to move to the next digit.
 When you try to change the current setting and Password Protection is enabled for the meter, the
Password screen appears. See the previous page for instructions on entering a password.
7. Once you have entered the new setting, press the Menu button twice.
8. The  screen appears. You can either:
• Press the Enter button to save the new setting.
• Press the Right button to access the screen; then press the Enter button to cancel the Save.
9. If you have saved the settings, the  screen appears and the meter resets.
Press the Enter button to save the settings Press the Enter button to The settings have been saved
Press the Right button for Stor All no screen Cancel the save