Receipt/Unpacking
6 S811+ Soft Starter MN03900001E—November 2012
Receipt/Unpacking
General
Upon receipt of the unit, verify that the catalog number and
unit options stated on the shipping container match those
stated on the order/purchase form.
Inspect the equipment upon delivery. Report any crate or
carton damage to the carrier prior to accepting the delivery.
Have this information noted on the freight bill. Eaton is not
responsible for damage incurred in shipping.
Unpacking
Carefully remove the unit from the shipping container. Check
the unit for any signs of shipping damage. If damage is found
after unpacking, report it to the freight company. Retain the
packaging materials for carrier to review.
Verify that the unit’s catalog number and options match
those stated on the order/purchase form.
CAUTION
Unit may weigh up to 103 pounds. Use suitable lifting device.
Storage
It is recommended that the unit be stored in its original
shipping box/crate until it is to be installed.
The unit should be stored in a location where:
●
The ambient temperature is –58° to 158°F (–50° to 70°C)
●
The relative humidity is 0–95%, non-condensing
●
The environment is dry, clean and non-corrosive
●
The unit will not be subjected to shock in excess of 15g’s
and/or vibration exceeding 3g in any direction.
Shipping
S811+Soft Starters are to be shipped in packaging that
adequately protects the unit.
S811+ units installed in an OEM system as a mounted
assembly in a cabinet or panel in enclosed control systems
are to be adequately secured and shipped via Air-Ride carrier
to prevent damage from excessive shock or vibration during
shipment.
To Next Page
Loading...
Need help?
General
