Trou bl es hoot i n g
S811+ Soft Starter MN03900001E—November 2012 41
Troubleshooting
General
In this section of the manual, we present a procedure you
can follow to diagnose a problem with your S811+.
While many potential situations are outlined in this section, it
is possible you may run into a problem that is not covered
here. If you have worked through the following
troubleshooting procedure and find that you require further
assistance, please contact Eaton.
Please have the following information ready when you call:
Before You Begin to Troubleshoot
Make sure you read and understand the procedures in
this manual before you attempt to set up or operate the
equipment.
HIGH VOLTAGE. Do not work on energized equipment
unless absolutely required. If the troubleshooting
procedure requires equipment to be energized, all work
must be performed by properly qualified personnel,
following appropriate safety practices and precautionary
measure.
We highly recommend that you read this entire section of
the manual before you begin to troubleshoot the S811+ Soft
Starter.
You may want to obtain the following equipment to aid you in
troubleshooting:
●
Multimeter
●
Clamp-on ammeter
Always assume the S811+ has high voltage applied and take
proper precautions while troubleshooting the soft starter and
associated equipment. Read all precautions at the front of
this manual before starting the troubleshooting process.
Order Number:
Catalog Number:
Style Number:
Serial Number:
To Next Page
Loading...
Need help?
General
