SAW CHAIN LUBRICATION SYSTEM
CS-2510TES
250Ts, 250TCs
49
7-2 Inspecting oil tank vent
NOTE:
Oil tank vent prevents a vacuum from
forming in oil tank when chain oil in the tank is con-
sumed.
1. Remove starter assembly.
2. Push oil tank vent (A) into oil tank using suitable
tool and take out vent (A) from oil tank.
3.Clean oil tank vent (A).
4. Check that oil tank vent lips (a) are not hard or
deformed. Replace as required.
4. Install oil tank vent (A) using suitable tool (B) as
shown.
5. Reassemble starter assembly.
a
A
A
B
To Next Page
Loading...
Need help?
General
