Ecotechnics ECK FLAG - Page 46

INSTRUCTIONS MANUAL
-47-
Unscrew HP and LP coupling without disconnect from A/C system end press to continue:
The machine will recover the residual refrigerant into the service hoses, then the following
screen will be displayed:
Disconnect coupling from A/C system.
Press the symbol for printing.
Type the plate of the car, VIN, Km, Operator and press to confirm. BACK to return back.
Procedure is now successfully completed.
NOTE: Rarely, charging may not run to completion due to pressure balance. In this case, close
the high pressure tap (leaving the low-pressure side open), and switch on the A/C system.
DD/MM/YY XX:XX PM
MANUAL / RECOVERY
Plate
VIN
Km
Operator
I____I
z
< x I
x
c
v b
m
s
d
f
g h
j k
a l
^
123
q
w
e
r
t
y
u
i
o
p
n
Close HP and LP couplings without disconnected
from A/C system and press to continue
DD/MM/YY XX:XX PM
MANUAL / OIL-UV INJECTION
Empty hoses
DD/MM/YY XX:XX PM
AUTOMATIC / EMPTY HOSES
Hoses pressure
4.01 bar
END OF PROCEDURE
Disconnected HP and LP coupling from A/C system
DD/MM/YY XX:XX PM
MANUAL / OIL UV INJECTION
Refrigerant charged
100 g
Oil injected
10 ml
UV injected
20 ml