Ecotechnics ECK FLAG - STATIC DIAGNOSIS (Optional)

INSTRUCTIONS MANUAL
-63-
STATIC DIAGNOSIS
(optional)
NOTE: during STATIC DIAGNOSIS, it is not necessary connect the service hoses to the A/C
system
From the MANUAL PROCEDURE, select STATIC DIAGNOSIS:
Then select STATIC DIAGNOSIS, the following screen will be displayed:
select the A/C system type
NOTE: Incorrect selection of A/C system type may falsify diagnostic results.
The following screen will be displayed:
Type in, in order, the minimum value of low pressure, the maximum and minimum value of high
pressure of the A/C system, and the temperature of the air at the outlet from the vents in the
passenger compartment (use the thermometer supplied with the machine to measure).
Then press OK to confirm, the following screen will be displayed:
DD/MM/YY XX:XX PM
MANUAL
Test N2
Hybrid – flushing hoses
Refrigerant analysis
Flushing kit
Static Diagnosis
DD/MM/YY XX:XX PM
MANUAL / STATIC DIAGNOSIS
Exp.value system
Orifice tube system
Orifice tube system running compressor
Type of A/C system
DD/MM/YY XX:XX PM
MANUAL / STATIC DIAGNOSIS
1 2
3
4
5
6
7
8
9
0
.
<
Lp min bar bar
Hp min bar °C
Tv °C
0.0
0.0
0.0
0.0
0.0