Index
Interference, shielding against, 5-3
Internal clock, troubleshooting, 8-3
IPTS-68, 5-4
Selecting, 4-11
ITS-90, 5-4
Selecting, 4-11
Test report, A-1
K
Keys, 4-1
Arrow, 4-3
Enter, 4-2
Escape, 4-2
Installation, 9-10
Keypad, 4-2
Menu, 4-2
Removal, 9-9
Testing, 4-22
Troubleshooting, 8-3
Knob (encoder), 4-3
L
LCD display, see Display.
LCD test, 4-22
Logging interval, setting, 4-17
M
Main display (operating screen), 4-3
Main menu, 4-8
Maintenance menu, 4-21
Manual, overview, 1-2
Manual sequence stepping, 4-15
Material, wire, 4-4
Setting, 4-11
Memory menu, 4-12
Menu key, 4-2
Menus, 4-8
Data logging, 4-16
Diagnostics, 4-22
Display, 4-17
Instrument mode, 4-10
Maintenance, 4-21
Memory, 4-12
Output, 4-11
Remote, 4-18
Sequence, 4-14
Thermocouple, 4-8
Messages, 4-6
A/D subsystem, 4-7
Alignment switch on, 4-6
Autozero (AZ), 4-12, 5-5
Batt flt, 4-7
Batt OK, 4-7
Charged, 4-6
Charging, 4-6
Interface board errors, 4-7
Low batt, 4-7
Other, 4-7
Out of range, 4-6
Overload, 4-6
Standby, 4-6
System errors, 4-7
Temp flt, 4-7
Meter mode, 5-1
Selecting, 4-10
Specifications, 2-2
Mini-three-pin thermocouple connector,
applications, 5-2
Mode
Instrument (source and measure), 4-4, 4-10
Output, 4-10
Standby, 4-1, 4-6
Model 1120 Remote Emulation, 4-18, 6-12
Background, 6-12
Command processing, 6-12
Default thermocouple type at power-up,
6-13
Errors, 6-14
GPIB parallel and serial poll, 6-13
Limitations, 6-12
Local lockout, 6-13
Meter and source modes in, 6-13
Numeric editing, 6-13
Operation, 6-14
Packet delimiter, 6-12
Standby, 6-13
Moving a step in a sequence, 4-14
Index 3
To Next Page
Loading...