5 Configuring System
ED-HMI2120-101C User Manual 5-12
6. Verify the success of mounting the storage device by executing the following command.
ls /mnt/mydisk
After executing the command, if the displayed information lists all files in the storage
device, it means that the mount is successful.
After executing the command, if the displayed information does not list the contents of
related files, it means that the mount is failed.
5.3.2 Unmounting The Storage Device
When the ED-HMI2120-101C is turned off, it is necessary to manually unmount the storage device so
that it can be pulled out safely.
NOTE:
Both Lite and Desktop versions of the system need to manually unmount the storage device.
Preparation:
The storage device has been successfully mounted.
Steps:
If "/mnt" is the mounted directory and "mydisk" is the name of the mount point, you can execute
the following command to complete the unmounting.
sudo umount /mnt/mydisk
After executing the command, if no error message is displayed, it means that the
unmounting has been completed and the storage device can be completely pulled out.
After executing the command, if an error message is displayed, it means that the
unmounting is failed.
5.3.3 Set The Storage Device To Mount Automatically
If you are using the Lite version of operating system, you can automatically mount it by modifying the
fstab settings.
Preparation:
To Next Page
Loading...