EDAN C6A - Adjusting the Swing Arm Stand; Placing;Moving the Stand

C3A, C6A, C6A HDVideoColposcope User ManualBasic Operations
- 21 -
Figure 3-3
CAUTION
Do not exert pressure downward more than 15 kg on the camera or it may hurt you or
damage the device.
3.3 Adjusting the Swing Arm Stand
3.3.1 Placing/Moving the Stand
Each stand caster has a pedal. Step down the pedal can lock the caster.
When the stand is placed somewhere, step down the pedals to lock the casters and stop the stand
from moving around.
When you need to move the stand, hold the stand post with your hand and then push up the
pedalsto release the casters. After you move the stand to the destination, step down the pedals
again.
CAUTION
1. Do not move the stand by holding the camera handle, otherwise the camera may be
damaged.
2. When moving the stand, avoid the camera from hitting the door frame or other
objects.
3. If the laptop tray or keyboard tray is configured, remove the laptop or keyboard
placed on the tray before you move the stand. Otherwise, the laptop or keyboard may
fall down.
4. If the monitor supporter is configured, avoid the monitor or all-in-one PC installed on it
from hitting the doorframe or other objects when you move the stand.
Horizontal angle adjustment knob
Vertical angle adjustment knob