C3A, C6A, C6A HDVideoColposcope User ManualApplication of the Video Colposcope Software
- 85 -
2) Click the Scanner Setup at the lower right corner of window.
3) Select Enable and choose Unicode mode or UTF-8 mode.
4) Set the Start Address and End Address of the patient number, first name, second name
and birthday according to Unicode rule or UTF-8 rule and click Save.
5) Exit the system and restart the software immediately.
5.12.2.20 Module Customization
Users can select modules displayed on the main interface through Module Customization.
1）Click the Setup button and then click the General Setup tag.
2）Click the Module Customization button and select the modules on the displayed page.
Patient’s InfoandSetup are selected by default and can’t be modified. Examine, Analysis,
Report, Operation, Database, Statistics, Switch User and Exit are selected by default and
can be modified.Report （ Edit Content） ,Analysis and Report cannot be selected
simultaneously.
3）After the modification, click Save and “The setting change will take effect when running the
software next time. Please restart the software.” will be displayed. Click OK and restart the
software,the modified setup will take effect.
5.12.3 Database Management
5.12.3.1 Backing up Database
1) Click the Setupbutton to open the Setupinterface.
2) On the Database tab, select the backup path. The default path is D:\DataBaseBackup.
3) Selectthebackuptype(Auto BackuporManualBackup).If you select Auto Backup, you
need to select number of days (1-100), and automatic backup is started after the software
is restarted. If you select Manual Backup, click Start Backup to start the backup.
4) Click OK.
5) Exit the system and restart the software immediately.
NOTE:
You can backup images in manual backupbut not in auto backup.
To Next Page
Loading...
